|
|
|
|
|
#1
10-30-2005, 03:07 PM
|
|||
|
|||
1996 SL 320 Hardtop Problem
The hardtop button stays illumniated as does the rollbar switch. I tried to remove the hardtop as per the instructions: set parking brake, lower windows, turn key to lock position, and actuate switch within 10 seconds. All I hear is a relay or switch trying to work, but nothing. I have put a new battery in and I had to set the radio code, does the car need to be reset also? Confusing any HELP???!!!
|
|
#2
10-30-2005, 04:21 PM
|
||||
|
||||
|
Oh, I just went through this on my 91 sl. Look further down in this forum and you'll find my post and all the replies and help from everybody.
Below is the address of the thread. http://www.peachparts.com/shopforum/showthread.php?t=134328
__________________
Thank You! Fred 2009 ML350 2004 SL600 2004 SL500 1996 SL600 2002 SLK32 2005 CLK320 cabrio 2003 ML350 1997 C280 Sport Last edited by waybomb; 10-30-2005 at 10:40 PM.
|
|
#3
11-01-2005, 08:55 AM
|
|||
|
|||
|
If you replaced the batter you will need to resync your windows. put them in the up position, hold both window buttons down (up position) and count to 3. That should fix it. Your engine can not be running to remove the hard top on this model. The ignition has to be on. You reset the rollbar the same way.
Brian
__________________
Brian W. Heitman www.MBCA.org/northtexas Join MBCA!!!
|
|
#4
11-04-2005, 04:42 PM
|
|||
|
|||
Top is fixed
I took the SL to the local MB dealer, they put it on the computer and scanned for codes. The main code was a low/no battery code. This locks the hardtop out, and illuminates the hardtop and rollbar buttons. Problem fixed!!! And as far as the windows, I reset them as I was instructed by the members, THANK YOU!! It was suggested that if the vehicle is to be stored a battery tender be used. This will switch on and off to trickle chsrge the battery when needed.
|
 |
| Bookmarks |
|
|
Linear Mode
