What are the symptoms of worn Guide Rod Mounts?

a clunk from the front end when brakes are applied espesialy at low speed when coming to complete stop. If rubber boot is bad on them they are probably shot .It is a DIY project if you have done some other rather involved front end work as there is one step where a lot of pressure must be used(I use a come along) and could it be potentially dangerous if not done right.........
William Rogers........

For me, it was 'multiple' *thunking* noises whenever driving over rough surfaces. Sort of the same noise you'd expect if you had a loose suspension component.

I'd always heard that the mounts would only make SINGLE clunk noises whenever stopping or taking off from a start....and it seemed to make sense. But, this certainly was NOT the case for me. In fact, I did NOT have the typical single clunk noises as normally indicated.

__________________
Chris
1985 300SD - 'Grace' (198K mi.)
2018 Honda Civic Sport
2018 Honda CRV LX
2010 Honda Fit Sport (RIP)
2013 Honda Accord Sport (Sold)
1996 Lexus LS400 (Retired)
1995 Ford Contour SE (Retired)
1976 Porsche 914 (Sold)
1972 Datsun 240Z (RIP)

Thanks guys for the info.