|
|
|
|
|
#1
04-18-2002, 02:25 AM
|
|||
|
|||
|
190e 16v help
hi
i need to put a new wiper switch in 86 190 16v do i have to take the wheel off to get at the cover? where is the sterring cover bolts. clips? i also noticed that someone else has tried to take the wheel off and the 10mm bolt in there is looking alittle striped any advice? thanks dave 
|
|
#2
04-18-2002, 02:47 AM
|
|||
|
|||
|
also i might add...
i have not driven the 16v in 3 months, today i drove it 100 miles to clean it up ,and at some stop lights when i came to idle the engine was jumping from 500 to 1500 rpm, give it gas it stoped then came back but didnt stall, and at idle for longer then 5 min the o2 light comes on,then goes off when driving???? the car must have not liked this winter thaks again dave
|
|
#3
04-18-2002, 09:18 AM
|
|||
|
|||
|
The steering wheel must come off to replace the switch!
On USA versions of this car only a bad O2 sensor OR intermittant power supply to the CIS computer will cause this light to come on & then back off.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 500E vs. 190E 16v | pentoman | Mercedes-Benz Performance Paddock | 25 | 02-26-2007 02:46 PM |
| 190E 16v vs. 190E 2.6 Sportline Question | ke6dcj | Mercedes-Benz Performance Paddock | 6 | 09-03-2004 05:20 PM |
| 190E 8V to 16V conversion | Monchit | Mercedes-Benz Performance Paddock | 1 | 09-22-2003 06:12 PM |
| 190E front hub bolt patterns: 190E 2.3 vs. 190E 16v | haasman | Tech Help | 5 | 04-02-2003 05:29 PM |
| 190E 16v Wheels on 190E 8v? | JohnEspeed | Mercedes-Benz Wheels & Tires | 1 | 03-28-2002 02:01 AM |
Linear Mode
