Picked up two for a few of my rides today and am curious what is needed to install these doo-dads. Special tools? Tips?

Thanks

__________________
I'm not a doctor, but I'll have a look.

'85 300SD 245k
'87 300SDL 251k
'90 300SEL 326k

Six others from BMW, GM, and Ford.

Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG]

Not too difficult. Need the keyswitch in the #1 position.

Look at the replacement tumbler and observe the locking pawl. You're going to insert a jewelers screwdriver down the slot and lever that pawl back into the housing.

When you do that, you can rotate the outer sleeve (90 degree needlenose pliers with taped jaws are the best) until it is fully removed. If you let go of the locking pawl in the process, it will catch the sleeve on each revolution and stop it from rotating. Once the outer sleeve is removed, the tumbler comes straight out of the housing.

I found the pics in the DIY section of this forum a great help. Especially the hard to see "pin" that needs to be depressed if you plan on replacing the lock cylinder too.
Either way, the pics may help you out some. Good luck

__________________


Selling used Mercedes parts on Ebay...always changing...
cdplayer51 take a look!
____________