|
|
|
|
|
#1
02-20-2001, 12:59 AM
|
|||
|
|||
|
Does anyone know if there is a Flywheel bolt for an M130 engine that is the same length as the flywheel bolt for the M180 engine? The M130 bolt is 12mm in diameter and the M180 is 10mm. The 12mm in diameter bolt is approximatly 10mm longer than the 10mm in diameter bolt.
Justin 
|
|
#2
02-20-2001, 09:23 AM
|
|||
|
|||
|
If its a automatic it is 1089900419 x's 6 and for the manual trans its a 1080320171 x's 6 each the ones for the manual are availble in fast lane the automatics have to be special orderd. Hope this helps you
|
|
#4
02-20-2001, 09:53 AM
|
|||
|
|||
|
ok, after 11 am est check bach here.
|
|
#6
02-20-2001, 01:16 PM
|
|||
|
|||
|
Your bolt is as follows, 30.23 mm long, the thread on the bolt is 10mm long (just what is threaded) the diameter is 11.68 mm. Good luck!
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rust Free 82 300SD in Dallas TX needs new home!!! | bodyart27 | Diesel Discussion | 47 | 08-07-2004 09:54 AM |
| Flywheel for a 300E engine | Maddog | Mercedes-Benz Performance Paddock | 5 | 07-17-2002 06:14 PM |
| 85 300D engine mount changeout.%#@! I stripped a hex bolt... | Carrameow | Tech Help | 9 | 05-30-2002 01:00 PM |
| Cold Running Engine Problem | hippie_elmo | Vintage Mercedes Forum | 1 | 01-25-2002 10:31 AM |
| Problem starting engine after overhaul | Stephan | Tech Help | 3 | 04-23-1999 09:32 PM |
Linear Mode
