|
|
|
#1
|
||||
|
||||
M104 VVT Problem,11 new valves later
i have this car back together. The previous tech who worked on the car did not torque the cam bolts right. Well the intake cam bolts came out(and were trapped in the vvt unit). this is where the 11 bent valves come in.Because of this problem the vvt could not work with the bolts trapped in there.
Now its fixed and i reassembled the vvt.Runs very well.more power than before.except that with the vvt hooked up,when it kicks in there is a horrible noise from the vvt(?) vvt is not plugged in right now. Is there a timing sequence to assemble the vvt, such as timing marks on the gears? If not my pistons are hitting the valves.find this hard to believe because it runs so good with better compression, vacuum and power. I hot wired the vvt and checked compression and got higher compression by about 10-15 psi When i timed the cams i turned the intake gear clockwise first,then set the drill holes at the head. The problem that i may have is i could not put the drill bits in. on both sides half the hole was above the head surface and the other half below the surface. the head was shaved only a little during the valve job.When i moved the chain 1 notch the intake cam hole was about half inch above the head surface,as it was before all this happened. I put the cam back to being even with head surface. The hole a little above and below the head surface. like a half moon above on each side. Sorry for the long post. I did change all the chain guides and new tensioner. Left the OE chain because i could not buy a one piece chain, even at the dealer.151k miles can put a link type in later. Help Rich
__________________
88 300E White, sold 9-04 88 190E Black 2.3 sold 90 300CE White, Grey sold 12-24-04 92 400E White,Grey Sold 5-06 90 300CE 91K Signal Red,Black Sold 2007 1989 300CE Smoke silver,Tan Sold 1-08 1993 300E 3.2 M104 motor 1991 300CE White,Grey 1994 E420 beautiful car,gone to new home 1994 E320 Smoke an Parchment.Beautiful car |
#2
|
||||
|
||||
ttt
The variable cam timing has me kind of stumped. Thanks Rich
__________________
88 300E White, sold 9-04 88 190E Black 2.3 sold 90 300CE White, Grey sold 12-24-04 92 400E White,Grey Sold 5-06 90 300CE 91K Signal Red,Black Sold 2007 1989 300CE Smoke silver,Tan Sold 1-08 1993 300E 3.2 M104 motor 1991 300CE White,Grey 1994 E420 beautiful car,gone to new home 1994 E320 Smoke an Parchment.Beautiful car |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switchover valves | erubin | Diesel Discussion | 23 | 04-25-2005 10:30 AM |
Why do valves get tight? | Jimmy Joe | Diesel Discussion | 12 | 12-23-2004 03:40 PM |
Fan clutch - M104 on M119 anyone done it? | moruzzi | Tech Help | 4 | 05-18-2004 07:04 PM |
The value of valves. | rower30 | Mercedes-Benz Performance Paddock | 2 | 06-09-2000 07:58 PM |
6.9 leveling valves | revbond | Tech Help | 1 | 08-30-1999 09:33 PM |