Ive tried searching on here and superturbodiesel for the torque for the rod nuts. its not in the haynes manual and it didnt come up in a google search. Any help is appreciated, i need to be able to put it back together tomorrow.

Measure the minimum necked down-down diameter prior to re-use.
NOTE: Replace when the minimum necked down-down diameter is 8.0 mm or less.

Initial tightening torque 40-50 Nm

then
Angle of rotation torque 90° -100°

ATTENTION:
If the bolts are replaced/knocked in with a hammer..
Tighten the first time to 60-70 Nm

then
Angle of rotation torque 90° -100°

WARNING:
Do NOT use a torque wrench for Angle of rotation torque = it can/will give a false angle reading..
.

Attached Thumbnails

 

__________________
ASE Master Mechanic
https://whunter.carrd.co/

Prototype R&D/testing:
Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician.
Noise Vibration and Harshness (NVH).
Dynamometer.
Heat exchanger durability.
HV-A/C Climate Control.
Vehicle build.
Fleet Durability
Technical Quality Auditor.
Automotive Technical Writer

1985 300SD
1983 300D
2003 Volvo V70

https://www.boldegoist.com/