Hey, dieselbeagel - delivery valve holder tightening torque - PeachParts Mercedes-Benz Forum

sixto · #1 07-11-2005, 11:16 PM

db,

Here's what you won't find in the shop manual.

Sixto
95 S420
87 300SDL

Quote:

Originally Posted by gsxr

Here's what the TDM says, word for word:

To obtain a correct seat of delivery valve holder sealing rings, tighten delivery valve holder to 30Nm and release, tighten once again to 30Nm and release again, then finally tighten to 30+5 Nm. Excessive tightening may cause a leak on elements at low and high pressure end by distortion of injection pump housing.

Interprest as you wish...

dieselbeagel · #2 07-12-2005, 10:52 AM

Thanks ! I will tackle this job once I get the seals and o rings.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
190D delivery valve holder seals	BRAD	Tech Help	6	09-19-2003 07:20 PM
603 IP Pressure Valve Torque Procedure?	ezrider	Diesel Discussion	2	02-19-2003 08:37 AM
Mechanical feature of accelerator pedal on torque delivery: 300 SD	turbodiesel300	Diesel Discussion	8	02-17-2002 09:46 PM
350 SDL Hammering at Idle - Replaced Delivery Valve O Rings	stephenson	Tech Help	4	08-16-2001 03:14 PM