|
|
|
|
|
#1
09-19-2013, 12:37 AM
|
||||
|
||||
|
Signs and symtoms of a failing ECM/ECU
Tried everything on my 400E still starts up fine runs good for 10-15 min then starts to stumble mis and go into limp mode and some times die. Sut it off cool it off and it does it again??? Could it be the computer ??? Everything else has been changed, any help will be appreciated GREATLY
Plugs Wires Coils Fpr EZL Temp sensor Fuel filter and relay CPS Fuel pressure tested Harness Battery Starter Alternator Had the ETA bench tested and wiring was fine And some other stuff I'm sure I forgot!!!! No check engine light 
|
|
#2
09-19-2013, 08:08 AM
|
||||
|
||||
|
caps/rotors.
Jim
__________________
14 E250 BlueTEC black. 45k miles 95 E320 Cabriolet Emerald green 66k miles 94 E320 Cabriolet Emerald green 152k miles 85 300TD 4 spd man, euro bumpers and lights, 15" Pentas dark blue 274k miles
|
|
#3
09-19-2013, 12:03 PM
|
||||
|
||||
|
Sorry I new I missed some thing there brand new
|
|
#4
09-20-2013, 06:19 AM
|
||||
|
||||
|
generally on GM and Fords it would be the ignition module,or part that controls spark.They get warm and fail.I don't know what controls spark on your car.However you can get a can of Freeze Mist for electronics store,and spray any locations that control spark.It ussally freezes the circut board so contact can be made with defective part.
__________________
1999 w140, quit voting to old, and to old to fight, a god damned veteran,you are a citizen of the world, all peoples are cousin's, love all life, your love is enternal
|
 |
| Bookmarks |
|
|
Linear Mode
