Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 2 of 16 1 2 3412 Last »
Showing results 31 to 60 of 473
Search took 0.08 seconds; generated 3314 minute(s) ago. Search: Posts Made By: J. M. van Swaay
Forum: Tech Help 11-11-2011, 05:30 PM
Replies: 17
Views: 1,796
Posted By J. M. van Swaay
The value of a 94/95 E320 is very very dependent...

The value of a 94/95 E320 is very very dependent on the status of the expensive to repair common failure items. These items are: wire harness, throttle actuator, head gasket, AC evporator, and...
Forum: Tech Help 11-11-2011, 10:30 AM
Replies: 20
Views: 7,292
Posted By J. M. van Swaay
According to the data card for your VIN, your car...

According to the data card for your VIN, your car was delivered from the factory with a 722.369 transmission. That's a 4 speed automatic. I suppose your car could have been modified, but that would...
Forum: Tech Help 09-29-2011, 08:02 PM
Replies: 7
Views: 2,376
Posted By J. M. van Swaay
Everything you need to know is right here: ...

Everything you need to know is right here:

How to rewire an M104 Throttle Actuator - Benzworld.org - Mercedes-Benz Discussion Forum...
Forum: Tech Help 08-26-2011, 08:57 PM
Replies: 10
Views: 3,816
Posted By J. M. van Swaay
Might want to check the valve above the right...

Might want to check the valve above the right rear axle. That's where mine was leaking.

J. M. van Swaay
Forum: Tech Help 08-06-2011, 10:58 AM
Replies: 5
Views: 986
Posted By J. M. van Swaay
This should help...... ...

This should help......


http://www.peachparts.com/Wikka/W124DoorPanel


J. M. van Swaay
Forum: Tech Help 07-23-2011, 09:09 AM
Replies: 8
Views: 1,066
Posted By J. M. van Swaay
Any chance the vac mod was recently...

Any chance the vac mod was recently removed/replaced? It is very easy to incorrectly install the vac mod seal. The incorrect installation will result in a difficult to find leak. (ask me how I...
Forum: Tech Help 07-22-2011, 11:24 AM
Replies: 10
Views: 4,293
Posted By J. M. van Swaay
There are two choices for the rear seal. One is...

There are two choices for the rear seal. One is just like the original, the other is called a repair seal. The repair seal is dimensioned slightly different so that the lip of the seal does not...
Forum: Tech Help 05-12-2011, 11:41 PM
Replies: 4
Views: 1,065
Posted By J. M. van Swaay
Ask seller for VIN of donor car. Go to EPC, run...

Ask seller for VIN of donor car. Go to EPC, run VIN, check part number........

J. M. van Swaay
Forum: Tech Help 05-03-2011, 08:10 PM
Replies: 3
Views: 794
Posted By J. M. van Swaay
It's been a while, but if I remember correctly...

It's been a while, but if I remember correctly there should be a square shaped hole in the side of the HVAC box (black box that contains the AC evaporator, heater core and blower assembly) the probe...
Forum: Tech Help 05-03-2011, 08:08 AM
Replies: 7
Views: 5,647
Posted By J. M. van Swaay
Try this thread..... ...

Try this thread.....

http://www.peachparts.com/shopforum/showthread.php?t=261264&highlight=smog+pump

By the way, the smog pump can also be disabled by simply removing the magnetic clutch disc...
Forum: Tech Help 04-20-2011, 09:00 AM
Replies: 9
Views: 3,290
Posted By J. M. van Swaay
You can disassemble the connector that supplies...

You can disassemble the connector that supplies the taillight assembly. It just snaps apart. Once apart, you can solder directly to the pins--no cutting/splicing required.

J. M. van Swaay
Forum: Tech Help 03-24-2011, 10:59 PM
Replies: 7
Views: 1,569
Posted By J. M. van Swaay
A while back, somebody posted a tech article...

A while back, somebody posted a tech article about turned rotors vs new. If I remember correctly, the tech data show that turned rotors increased stopping distance by as much as 60%. The spiral...
Forum: Tech Help 03-23-2011, 06:49 PM
Replies: 13
Views: 4,255
Posted By J. M. van Swaay
Might also want to check for collapsed motor...

Might also want to check for collapsed motor mounts. If they have collapsed, the drive shaft will tilted slightly relative to the transmission output shaft. This will result in continuous flexing...
Forum: Tech Help 01-27-2011, 08:26 PM
Replies: 2
Views: 1,099
Posted By J. M. van Swaay
Thanks for the response. I haven't done a...

Thanks for the response. I haven't done a compression check--engine runs strong and produces very adequate power. Valves were done about 70K miles ago when I did the head gasket. I do have a...
Forum: Tech Help 01-27-2011, 09:42 AM
Replies: 2
Views: 1,099
Posted By J. M. van Swaay
722.369 vac mod question

1994 E320 Wagon
250,000 miles
original transmission (B3 friction discs replaced about 10K miles ago)
regular ATF fluid/filter changes since new

Over the last 6 months, car has developed...
Forum: Tech Help 01-24-2011, 06:55 PM
Replies: 11
Views: 1,108
Posted By J. M. van Swaay
Try a post with "94/95 E320 Cabrio" in the...

Try a post with "94/95 E320 Cabrio" in the header, I'll bet you get more hits.....

J. M. van Swaay
Forum: Tech Help 01-22-2011, 08:02 PM
Replies: 11
Views: 1,108
Posted By J. M. van Swaay
Been looking for a 95 E320 Cab for three years...

Been looking for a 95 E320 Cab for three years but haven't found the right one. (and I've looked at many) Then again, I'm very picky......

Obviously you know what my choice would be!

Good...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 10-22-2010, 11:58 AM
Replies: 1
Views: 456
Posted By J. M. van Swaay
Part numbers without spaces for search purposes: ...

Part numbers without spaces for search purposes:

0000940548
0280217500
Forum: Mercedes-Benz Used Parts For Sale & Wanted 10-22-2010, 11:39 AM
Replies: 1
Views: 456
Posted By J. M. van Swaay
FS: MAF (mass airflow sensor)

Mass airflow sensor (MAF) Used but tested in my 1994 E320 for several weeks. Guaranteed not DOA. No additional warranty after that. (If your car still has the original engine wire harness, there...
Forum: Tech Help 09-10-2010, 10:31 AM
Replies: 8
Views: 2,570
Posted By J. M. van Swaay
Generally, the front sway bar will only be under...

Generally, the front sway bar will only be under load if the suspension struts/springs are compressed asymmetrically. If your ramps and rear wheels are all on a level surface, there should no (or...
Forum: Tech Help 09-09-2010, 08:39 PM
Replies: 10
Views: 1,216
Posted By J. M. van Swaay
I was watcing the speed channel a few months ago....

I was watcing the speed channel a few months ago. I happened to tune in during a short piece on restorations. The narrarator did a plug for a vendor that sells raw wire bundles specifically for...
Forum: Tech Help 09-05-2010, 12:03 PM
Replies: 6
Views: 996
Posted By J. M. van Swaay
The clicking was probably the B3 (reverse) piston...

The clicking was probably the B3 (reverse) piston impacting the K1 clutch carrier. As Mr. Poole described, thin clutch discs allow the B3 piston to much travel. The clicking is most pronounced when...
Forum: Tech Help 08-30-2010, 12:43 PM
Replies: 11
Views: 3,157
Posted By J. M. van Swaay
Don't know if I have any more light to shed,...

Don't know if I have any more light to shed, sounds like you've already considered everything I might think to suggest.

Only other thing would be if the B2 reaction valve pin somehow wasn't...
Forum: Tech Help 08-30-2010, 09:56 AM
Replies: 9
Views: 4,748
Posted By J. M. van Swaay
You're not reading anything wrong. The install...

You're not reading anything wrong. The install descriptions that don't use relays are a bit misleading. There are hundreds of aftermarket keyless systems. Some have internal relays as part of the...
Forum: Tech Help 08-30-2010, 09:27 AM
Replies: 11
Views: 3,157
Posted By J. M. van Swaay
There is a service bulletin from ATSG about...

There is a service bulletin from ATSG about delayed engagement of forward gears after replacing the B2 seals. If you installed the new style seal on an old style piston, this could be part of your...
Forum: Tech Help 08-29-2010, 10:17 PM
Replies: 9
Views: 4,748
Posted By J. M. van Swaay
The only type of output available from the REC43T...

The only type of output available from the REC43T is a "sink to ground" ie, a ground supply. This ground supply can be used as a direct input to a control module, or it can be used to supply ground...
Forum: Tech Help 08-29-2010, 06:15 PM
Replies: 9
Views: 4,748
Posted By J. M. van Swaay
You will need two relays. Check out this link...

You will need two relays. Check out this link for some more information:

http://www.peachparts.com/Wikka/W124Keyless

J. M. van Swaay
Forum: Tech Help 08-18-2010, 01:28 PM
Replies: 14
Views: 1,335
Posted By J. M. van Swaay
When installing the new fan, be sure to check the...

When installing the new fan, be sure to check the direction of rotation before reassembling everything. There was a production run of these fans that had the polarity reversed. (Ask me how I...
Forum: Tech Help 08-15-2010, 08:14 AM
Replies: 6
Views: 1,016
Posted By J. M. van Swaay
Could you please post which version of the 722...

Could you please post which version of the 722 tranny you have installed? Should be something like 722.3XX.

Thanks

J. M. van Swaay
Forum: Tech Help 08-13-2010, 08:35 AM
Replies: 7
Views: 1,247
Posted By J. M. van Swaay
Hope the OVP is your problem because it is a...

Hope the OVP is your problem because it is a relatively easy and inexpensive fix.

J. M. van Swaay
Showing results 31 to 60 of 473
Page 2 of 16 1 2 3412 Last »

 
Forum Jump


All times are GMT -4. The time now is 02:49 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Friendly URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page