Thread: Thermo Vacuum Valve - Electrical Sensor in its place??
View Single Post
  #6  
Old 12-10-2011, 07:52 PM
whunter's Avatar
whunter whunter is offline
Moderator
  
Join Date: Dec 2003
Location: Metro Detroit, Michigan
Posts: 17,422
Answer
Quote:
Originally Posted by SpecialDelivery View Post
Check this out...I'm going about rebuilding my first Benz..a 1982 300SD I'm working on the 3/2 vacuum "situation" and I see this strange sensor where there should be a vacuum thermo valve


So I bought a thermo vac valve, and the diameter of the threads is significantly smaller than the hole this sensor is mounted into...can anyone shed some light here? I cant find any info about this in the FSM, or elsewhere...maybe I havent looked hard enough?

another view..


any info you vets could share with this n00b would be greatly appreciated!!
You are worried over a none issue.
Disconnect and plug the EGR vacuum circuit, it is useless + sludge's the intake ports/manifold.

The device in the thermostat housing is a temperature sensor, look for the wire, but if all the gauges work = someone may have swapped out a corroded thermostat housing for one from another engine.

.
__________________
ASE Master Mechanic
https://whunter.carrd.co/

Prototype R&D/testing:
Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician.
Noise Vibration and Harshness (NVH).
Dynamometer.
Heat exchanger durability.
HV-A/C Climate Control.
Vehicle build.
Fleet Durability
Technical Quality Auditor.
Automotive Technical Writer

1985 300SD
1983 300D
2003 Volvo V70

https://www.boldegoist.com/
Reply With Quote