Hey Don!

Don't know if you remember me, but I'm almost done with the rust repairs Should be going to the shop for some stuff i dont have tools for next week.

Great advice, step-by-step, pics, and materials list, thank you. The tip about drilling a hole is really smart. Aligning hoods is the devil's work.

For getting off the old hood liner and getting it clean, did you scuff the hood up a little bit before putting on the adhesive and hood pad? Or does the 3M 77 hold it pretty well? I might've used a cup brush on a drill to get the residual adhesive and pad stuff off, used some kind of adhesive remover, then scuff up with a 40 grit piece of sand paper and then clean off before using the adhesive stuff + pad.

Also, i have 3M 90 which they say holds better than 77. Why did you use 77 vs 90? I figure stronger is better.

Again, great work. This is something I'll do down the road.

Bob