|
Pics Wiring 12V Facet fuel pump w/ relay.
Hi This is pics of wiring for hooking up a 12V facet fuel pump I use for assisting lift pump to pull WVO up to the IP.
DISCONNECT BATTERY AFTER YOU FIND YOUR HOT WIRE FROM FUSE BOX.
pic 1) Is just a hot wire coming out of the fuse box. Any one that works once the key is ON.
This wire connects to the relay switch.
pic # 2) Seperate wire connects to "this thing" near the battery; the middle screw inside this clip holds it in.
Ran from here to a relay switch. IMPORTANT TO INSTALL A FUSE LINK IN THIS WIRE. 12w FUSE SHOULD DO.
A relay has 4 conections. 1 for this hot wire from the little box next to the battery. 2. from the wire from the fuse box. 3 for power to the hot wire of your new pump. 4 to a ground. (mine is in pic 3 on the air intake screw up front.)
pic 3) Is a simple relay switch from the AP store; connected to my coolant resevoir. (follow directions for connections on the switch box; or see above...)
pic 4) Is the pump mounted under the rear pass side; It is mounted to the frame here with 2 fat screws into already existing holes on this support frame. When you look under here you will see lots of these holes to choose from. I also grounded to the frame from the pump.
pic 5....just the front end of an ol' 300D with it's proud HIgh mileage badge!!!!
__________________
'87 924S
'81 280SEL
Sold ->
81 300SD -
93 300E w/ 3.2
85 300D-
79 300SD
82 300CD
83 300CD - CA
87 190E 5 spd
87 Porsche 924S
"..I'll take a simple "C" to "G" and feel brand new about it..."
Last edited by Austin85; 05-09-2006 at 04:04 PM.
Reason: ADD PHOTO
|